What Size Screwdriver For Xbox One Controller

Introduction

This guide will teach y'all how to remove the buttons.

Remove the battery pack cover.

Remove the battery pack comprehend.
Remove batteries.

We recommend using a nylon spudger for this step. A metal spudger is shown.

We recommend using a nylon spudger for this pace. A metal spudger is shown.
Grip the controller firmly to remove the side handles, wedging a spudger into the seam between the front and handle plates.
Pry the side plate away from the front plate by moving the spudger dorsum and forth. You will demand to do this all the mode effectually the side plate's seam.

In that location is a hidden screw located in the eye of the controller backside the label.
Use a screwdriver and punch a hole straight in the center of the label.
You lot may also elevator the characterization if you do not desire to puncture information technology.
Remove the five 10mm screws located on the back of the controller using the T8 Security Torx Screwdriver.

Remove the backplate.

Remove the faceplate.

Y'all may let the rumble motors hang freely out of their sockets.
De-solder the soldered joints while holding the red and blackness wires downward on the top motherboard.
De-solder the black and gray wires that are fastened to the elevation motherboard.
Remove the rumble motors and set them bated.
Be careful while using the soldering fe non to damage other components or hurt yourself.
For information on how to solder, click here.

Unscrew the two 7mm T6 screws located near the rumble motor sockets.

Firmly grip sides of motherboard well-nigh the middle.
Elevator upward while slightly fluctuant the motherboard forward and astern.
Lifting the motherboard will require some force.

Remove the six T6 Torx screws located on the bottom motherboard.

Remove the bumpers by prying them off of the pegs that secure them, using a spudger. They are located on the front and back of the controller.
A standard nylon spudger is recommended for this step. Using a metal spudger near the motherboard equally shown risks damaging your device.

Lift the piece surrounding the Domicile push button off of its pegs.
Pry information technology off of the other side, using a spudger on the pins.
A standard nylon spudger is recommended for this step. Using a metal spudger most the motherboard as shown risks damaging your device.
Removing this slice may require a lot of force.

Remove the bottom motherboard.

Remove the safe backing to the buttons.

With the buttons facing down, push button them up out of their housings, and remove.

Conclusion

To reassemble your device, follow these instructions in opposite guild.

Team

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview

What Size Screwdriver For Xbox One Controller,

Source: https://www.ifixit.com/Guide/Xbox+One+Wireless+Controller+Buttons+Replacement/36845#:~:text=Remove%20the%20five%2010mm%20screws,the%20T8%20Security%20Torx%20Screwdriver.

Posted by: essaryhavesiont.blogspot.com